CISCO WS-X6348-RJ-45 CATALYST 6000 48PT 10/100 RJ45 MODULE

The WS-X6348-RJ45V 48-port 10/100BASE-T switching module provides 48 switched, 10/100-Mbps autosensing, full- or half-duplex ports. The module has 48 RJ-45 connectors for connection to either Category 3, Category 5, Category 5e, or Category 6 UTP or FTP cable. This module can be upgraded with an inline-power daughter card to support IP phones.

WS-X6348-RJ45V Features

• 48 ports 10/100BaseTX per module (RJ-45)?The module has up to 384 10/100 Fast Ethernet ports per Catalyst 6500/6000 family switch.
• Inline power?48-volt DC power is provided over standard Category 5 unshielded twisted-pair (UTP) cable up to 100 meters.
• Phone discovery?The Catalyst 6500/6000 family switch automatically detects the presence of an IP phone and supplies inline power. The phone discovery mechanism is intelligent enough to differentiate between an IP phone and a Network Interface Card (NIC). The phone discovery mechanism also does not supply inline power to a NIC or other device not designed to use inline power. Inline-powered devices that support CDP version 2 provide the power-supplying switch port with details on their power consumption level. This allows the switch to more accurately perform power accounting between the total load and the available power reserves. Inline-powered devices that do not support CDP, or devices that connect to ports where CDP is disabled, are allocated a nominal power consumption value of 7 watts for purposes of power accounting.
• Phone discovery?The Catalyst 6500/6000 family switch automatically detects the presence of an IP phone and supplies inline power. The phone discovery mechanism is intelligent enough to differentiate between an IP phone and a Network Interface Card (NIC). The phone discovery mechanism does not supply inline power to a NIC or other device not designed to use inline power. But it does not work if Cisco Discovery Protocol (CDP) is disabled. This uses CDP version 2.
• Auxiliary VLAN through 802.1Q?The Catalyst 6500/6000 family switch automatically segments phones and data endpoints into separate logical networks.
• The WS-X6348-RJ45Vmodule offers support for the IEEE 802.3u autonegotiation process that allows the switch to negotiate speed (10 or 100 Mbps) or duplex mode (half or full duplex) with an attached device.
• Capacity of up to eight modules per platform?These modules require one slot, they can be "mixed and matched" with other switching modules, and they can be hot-swapped or added as necessary without the interruption of the Catalyst 6500/6000 family switch. A maximum of 8 x 48 = 384 10/100 Fast Ethernet ports are supported.
• Superior traffic management, with large per-interface buffers and multiple priority queues.
• Support for multiple active MAC addresses (up to 32,000) on a switching port. You can also dynamically allocate the addresses to any port.
• Spanning-tree algorithm on logical VLANs for fault-tolerant connectivity?These modules can support up to 1000 VLANs.
• The WS-X6348-RJ45V module provides extensive management tools with the use of Simple Network Management Protocol (SNMP) platforms such as CiscoWorks for Switched Internetworks.
• Four remote monitoring (RMON) groups?Statistics, history, alarms, and events are supported in hardware.